ESP32-C3-DevKitM-1 Development Board (แท้จาก DFRobot)

ESP32-C3-DevKitM-1 Development Board (แท้จาก DFRobot)
ESP32-C3-DevKitM-1 Development Board (แท้จาก DFRobot)ESP32-C3-DevKitM-1 Development Board (แท้จาก DFRobot)ESP32-C3-DevKitM-1 Development Board (แท้จาก DFRobot)ESP32-C3-DevKitM-1 Development Board (แท้จาก DFRobot)ESP32-C3-DevKitM-1 Development Board (แท้จาก DFRobot)ESP32-C3-DevKitM-1 Development Board (แท้จาก DFRobot)
รหัสสินค้า BA00265
หมวดหมู่ WiFi ESP32
ราคา 885.00 บาท
สถานะสินค้า พร้อมส่ง
จำนวน
ชิ้น
หยิบลงตะกร้า
หนังสือรับรองบริษัท
บุ๊คแบ๊งค์
คุ้มครองโดย LnwPay
ดูการใช้งานอย่างละเอียดได้ที่ Click

INTRODUCTION
ESP32-C3-DevKitM-1 is an entry-level development board based on ESP32-C3-MINI-1, a module named for its small size. This board integrates complete Wi-Fi and Bluetooth LE functions.

Most of the I/O pins on the ESP32-C3-MINI-1 module are broken out to the pin headers on both sides of this board for easy interfacing. Developers can either connect peripherals with jumper wires or mount ESP32-C3-DevKitM-1 on a breadboard.

Description of Components

ESP32-C3-DevKitM-1 Development Board

 

Key Component Description
ESP32-C3-MINI-1 ESP32-C3-MINI-1 is a general-purpose Wi-Fi and Bluetooth LE combo module that comes with a PCB antenna. At the core of this module is ESP32-C3FN4, a chip that has an embedded flash of 4 MB. Since flash is packaged in the ESP32-C3FN4 chip, rather than integrated into the module, ESP32-C3-MINI-1 has a smaller package size.
5 V to 3.3 V LDO Power regulator that converts a 5 V supply into a 3.3 V output.
5 V Power On LED Turns on when the USB power is connected to the board.
I/O Connector All available GPIO pins (except for the SPI bus for flash) are broken out to the pin headers on the board.
Boot Button Download button. Holding down Boot and then pressing Reset initiates Firmware Download mode for downloading firmware through the serial port.
Micro-USB Port USB interface. Power supply for the board as well as the communication interface between a computer and the ESP32-C3FN4 chip.
Reset Button Press this button to restart the system.
USB to UART Bridge Single USB-to-UART bridge chip provides transfer rates up to 3 Mbps.
RGB LED Addressable RGB LED (WS2812), driven by GPIO8.

 

 

Pin Header

ESP32-C3-DevKitM-1 Development Board

SPECIFICATION

  • ESP32-C3FN4 embedded, 32-bit RISC-V single-core processor, up to 160 MHz
  • 384 KB ROM
  • 400 KB SRAM
  • 8 KB RTC SRAM
  • 4 MB SPI flash
  • Operating Voltage/Power supply: 3.0~3.6 V
  • Operating Temperature Range: –40~85°C

DOCUMENT

SHIPPING LIST

  • ESP32-C3-DevKitM-1 Development Board ×1

วิธีการชำระเงิน

ชำระเงินค่าสินค้าโดยการโอนเงินเข้าบัญชีธนาคาร KBANK, SCB, BBL,TMB

กรุณาเก็บหลักฐานการโอนเงินของท่านไว้เพื่อแจ้งการชำระเงินด้วยค่ะ

 

ท่านสามารถแจ้งการชำระเงินผ่านระบบอัตโนมัติได้โดย Click Link ข้างล่างค่ะ

https://www.arduitronics.com/informpayment

 

บมจ. ธนาคารกสิกรไทย สาขาเซ็นทรัล แจ้งวัฒนะ ออมทรัพย์
ธนาคารไทยพาณิชย์ จำกัด (มหาชน) สาขาเซ็นทรัล แจ้งวัฒนะ ออมทรัพย์
ธนาคารกรุงเทพ จำกัด (มหาชน) สาขาเซนทรัล พระราม 3 สะสมทรัพย์
ธนาคารทหารไทยธนชาต จำกัด (มหาชน) สาขาเซนทรัล พระราม 3 กระแสรายวัน

เพิ่มเพื่อน

@rfm0967y

ติดต่อสอบถาม

เพิ่มเพื่อน

CATEGORY

Sensors / Modules [1695]

CONTACT US

มือถือ 0887823467 แฟกซ์ 02-0153201

Join เป็นสมาชิกร้านค้า

ร้านArduitronics
ร้านArduitronics
/www.arduitronics.com/
Join เป็นสมาชิกร้าน
2118
สมัครสมาชิกร้านนี้ เพื่อรับสิทธิพิเศษ

STATISTICS

หน้าที่เข้าชม15,375,197 ครั้ง
ผู้ชมทั้งหมด5,878,275 ครั้ง
เปิดร้าน21 พ.ค. 2556
ร้านค้าอัพเดท5 ก.ย. 2568

MEMBER

พูดคุย-สอบถาม