W5500 Ethernet Network Arduino Module โมดูล Ethernet W5500

The W5500 module is a module based on Ethernet WIZNET new type of chip W5500, module integrates the whole hardware TCP/IP protocol stack, no need code implements the TCP/IP protocol stack, support transmission rate of 10/100MBPS, support sleep mode and wake on LAN ,Within the integrated 32K TX/RX cache,support  8 independent ports run at the same time,Module supports 3.3V or 5V power supply, convenient for the user to use in the SCM system different, module and MCU system communication mode is SPI protocol,Support SPI clock frequencies up to 80M, provide STM32 and 51 SCM client, server, three modes of UDP routines.

• Supports Hardwired TCP/IP Protocols : TCP, UDP, ICMP, IPv4, ARP, IGMP, PPPoE
• Supports 8 independent sockets simultaneously
• Supports Power down mode
• Supports Wake on LAN over UDP
• Supports High Speed Serial Peripheral Interfac(SPI MODE 0, 3)
• Internal 32Kbytes Memory for TX/RX Buffers
• 10BaseT/100BaseTX Ethernet PHY embedded
• Supports Auto Negotiation (Full and half duplex, 10 and 100-based )
• Not supports IP Fragmentation
• 3.3V operation with 5V I/O signal tolerance
• LED outputs (Full/Half duplex, Link, Speed, Active)
• 48 Pin LQFP Lead-Free Package (7x7mm, 0.5mm pitch)

• Chip type: W5500     
• Supports both 3.3V & 5V.     
• Hardwired TCP/IP Protocols : TCP, UDP, ICMP, IPv4, ARP, IGMP, PPPoE     
• 10BaseT/100BaseTX Ethernet PHY embedded     
• Supports automatic response (full duplex / half duplex mode)     
• Supports 8 independent sockets simultaneously     
• Internal 32Kbytes Memory for Tx/Rx Buffers     
• Power off mode: support     
• Network wake: support     
• SPI interface (SPI MODE 0, 3),convenient connection with MCU     
• Size: 55mm x 28mm     
• Color: Blue